Opencore plus time-out behavior, Opencore plus time-out behavior –8 – Altera DDR SDRAM High-Performance Controllers and ALTMEMPHY IP User Manual

Page 14

Advertising
background image

1–8

Chapter 1: About This IP

Installation and Licensing

External Memory Interface Handbook Volume 3

June 2011

Altera Corporation

Section I. DDR and DDR2 SDRAM Controllers with ALTMEMPHY IP User Guide

You need to purchase a license for the megafunction only when you are completely
satisfied with its functionality and performance, and want to take your design to
production.

OpenCore Plus Time-Out Behavior

OpenCore Plus hardware evaluation can support the following two modes of
operation:

Untethered—the design runs for a limited time

Tethered—requires a connection between your board and the host computer. If
tethered mode is supported by all megafunctions in a design, the device can
operate for a longer time or indefinitely

All megafunctions in a device time-out simultaneously when the most restrictive
evaluation time is reached. If there is more than one megafunction in a design, a
specific megafunction's time-out behavior may be masked by the time-out behavior of
the other megafunctions.

1

For MegaCore functions, the untethered time-out is 1 hour; the tethered time-out
value is indefinite.

Your design stops working after the hardware evaluation time expires and the
local_ready

output goes low.

Advertising
This manual is related to the following products: