Pointmaker CPN-5800 - Manual (Page 105)

Boeckeler Instruments, Inc. Pointmaker CPN-5800 Color Video Marker - Page 99
Section Five:Image Mobility Image Manipulation
b) (digital tablet) Activate the “Save” button.
c) (keyboard) Type “Alt-F6”.
The “Alt-F6” keyboard command is programmed to save to the Computer
where TFTP is installed. The other two commands are dependent on the
Destination setting in the Capture dialog(see Setting the Destination for Saved
Files, on page 47).
If you want to use the tablet or touch screen commands, be sure to set the
Destination to USB first.
2. The image is saved to the computer you have designated.
A counter appears at the lower-right portion of the screen, indicating the
percentage of the image saved to the TFTP server.
When the counter reaches 100, it disappears. The system is then ready to save
another image.
NOTE: Operation of the CPN-5800 will slow down during the saving
process.
The name of the file is determined by the settings in the File Defaults dialog
(see Figure 3-14: File Defaults dialog, on page 46).
Retrieving Images
Saved images can be retrieved using the “Get” command. A dialog appears,
allowing you to enter the number of the image you wish to on screen. When you
enter the number and activate the OK button, the image is dis played. To return to
the video input, again type the “Alt-F2” keyboard com mand.
To retrieve an image file from USB
1. Retrieve an image in one of the following ways:
a) (touch screen) Touch the appropriate area if you assigned this com-
mand.
b) (digital tablet) Activate the “Get” button.
c) (keyboard) Type “Alt-F3”.