Daktronics All Sport 4000 Series - Manual (Page 61)

Message Center
Operation
14-7
14.10 Configure Sign Size
Press the < MENU > key and use the menu down arrow key to select the option SELECT
SIZE Y/N . Press the < YES > key to configure the sign size. Select the appropriate sign size
by pressing any menu arrow key. When the correct size is shown on the LCD, press the
<
ENTER > key to select it. The All Sport 4000 control console must have the correct sign size
selected for animations to be displayed.
The configure sign size function only needs to be set when the MDC control board is installed or
replaced. The configure sign size function should be used if messages do not appear centered on
the display.
14.11 Display Test Sequences
There are two sequences available to test the pixels on the display. Sequence 21 is a moving
row/column pattern, and sequence 22 is an all-on pattern. Refer to Section 14.7 to display either
of these sequences for checking display operation.