SP Controls SmartPanel - Manual (Page 7)

SmartPanel Configuration and Installation Guide Page 3
© 2002-8 SP Controls, Inc. 930 Linden Avenue South San Francisco CA 94080 w
ww.spcontrols.com
Our goal was elegant and straightforward design. We hope that we succeeded and that you find
the Panel intuitive to use.
Two Form Factors to Fit Every Installation
The SmartPanel comes in two form factors to fit every installation and budget.
Full-Size SmartPanel
The assembled SmartPanel in Figure 1 is configurable with four Modules and three Auxiliary
Modules. The Modules provide point-of-control connection for portable projector sources, such
as laptops, so users can patch in and control the system at the same location.
Modules are chosen, ordered and attached by the installer. Selection-only Modules (with no
patch points) are available for permanently installed devices, and blanks are available for
installations that have fewer than four input devices.
Note: Facing the front of the Panel, the leftmost Module is “input one,” and the rightmost “input
four”.
Mini “Control-Only” SmartPanel
The Mini SmartPanel is an elegant, small-footprint alternative for installations where space or
aesthetics are at a premium. The Mini SmartPanel provides the same comprehensive control
over projectors as the full-size Panel, without integrated patch points. Auxiliary Patch Points can
be integrated when the Panel is mounted in a drawer (SBL-1050B) or rack (SP2-RACKSM-
MOD).
The Mini SmartPanel is available in several finishes to match any décor.
Note: Unless otherwise noted, instructions and directions apply to both form factors. The full-size
SmartPanel and control-only SmartPanel are identical from a configuration and wiring
perspective. Only the facia differs.