H3C Technologies H3C Intelligent Management Center User Manual
Page 150
140
a.
Click Select BIMS Spokes.
A window appears for you to select spokes.
b.
Enter query conditions in the Device Name, Serial Number, and Device IP boxes, which
support fuzzy query.
c.
Click Query.
d.
Select spoke devices from the BIMS Device List.
e.
Click OK.
2.
Modify settings for a spoke:
a.
Click the Modify icon
for that spoke device.
A window appears.
b.
Modify the private IP address of the spoke device.
The VAM server uses private IP addresses to identify VAM clients.
c.
Select a CA domain from the CA Domain list.
The CA Domain list displays CA domains that IVM obtains from the device. The CA domain
takes effect only when the IKE authentication type is CA Authentication. There is no need to
select a CA domain when the IKE authentication method is Pre-Shared Key.
d.
Click OK.
3.
To delete a spoke:
a.
Select the spoke device in the spoke device list.
b.
Click Delete Device.
4.
Configure other spoke settings:
a.
Enter the IP address and port of the primary VAM server in the Primary VAM Server IP and
Primary VAM Server Port boxes.
The Primary VAM Server IP and Primary VAM Server Port boxes are filled with the VAM
Server1 settings configured in "Configuring the VAM server." You can modify the settings at
this step.
b.
Enter the IP address and port of the secondary VAM server in the Secondary VAM Server IP
and Secondary VAM Server Port boxes.
The Secondary VAM Server IP and Secondary VAM Server Port boxes are filled with the VAM
Server2 settings configured in "
." The two options are available
only when VAM Server2 has been configured. You can modify the settings at this step.
c.
Enter the VAM client name of the spoke in the VAM Client Name box.
This setting corresponds to the CLI command vam client name client-name.
d.
Enter the AAA authentication username for Hub 1 in the VAM Username box.
If the authentication method is RADIUS, whether to include the domain name in the entered
username depends on the Username Format setting in RADIUS.
e.
Select the Plaintext or Ciphertext format for the AAA authentication key in the Password Type
field.
f.
Enter the AAA authentication key for the spoke in the VAM Password box.
g.
Enter the interval between VAM packet retransmissions in the Retransmission Interval box.
The default interval is 5 seconds.
h.
Enter the number of the tunnel interface.