Configuring and deploying a gre over ipsec tunnel – H3C Technologies H3C Intelligent Management Center User Manual
Page 187
177
a.
Click the Modify Spoke Device Info icon
next to a virtual spoke name.
The Modify Virtual Spoke Settings window appears.
b.
Modify the following parameters:
−
Device Name—Modify the name of the virtual spoke.
−
Interface Name—Modify the name of the spoke interface.
−
Interface IP—Modify the IP address of the virtual spoke interface.
c.
Click OK.
d.
To copy the name and address of the spoke interface to another tunnel, click the Clone this
address to all subsequent hubs icon
.
4.
Configure the IP address of the spoke interface:
a.
Click the Modify Gateway IP icon
for the IP address of a spoke interface.
The Modify Gateway IP window appears.
b.
Enter a new IP address.
c.
Click OK.
d.
To copy the IP address of the spoke interface to another tunnel, click the Copy icon
next to
a gateway IP address to copy the address to other tunnels.
e.
Click OK to go back to the Tunnel List page of the GRE over IPsec VPN domain.
Configuring and deploying a GRE over IPsec tunnel
1.
On the Tunnel List page, click the Configuration icon
for a GRE over IPsec tunnel to enter the
GRE over IPsec tunnel configuration page. The page contains the following tabs.
{
Basic Information
{
Device Parameters
{
Security Proposals
{
Spoke Additional Settings
{
Hub Advanced Settings
{
Spoke Advanced Settings
{
GRE Settings
2.
Follow the same procedure as described in "
Configuring existing GRE over IPsec tunnels
" to
configure the GRE over IPsec tunnel between the hub and virtual spoke.
3.
After the tunnel configuration is complete, click Back to go back to the Tunnel List page.
The configuration status of the tunnel is changed to Configured.
4.
Click the Operation icon
for the GRE over IPsec tunnel.
A menu appears for you to check the tunnel settings:
{
View Hub's Current Configuration
{
View IVM’s Configuration for Hub
{
View IVM’s Configuration for Spoke
5.
Click the menu options to verify that all settings are correct.
6.
Select the tunnel and click Deploy.
IVM deploys the tunnel configuration to the hub device of the tunnel.