3 test by comparison of position values 1 and 2 – HEIDENHAIN PWM 20 User Manual
Page 115
Advertising
116
HEIDENHAIN ATS Software User's Manual
5.6.3 Test by comparison of position values 1 and 2
For this test the position value 1 is compared to the position value 2. The values must not differ
by more than 1 bit.
8
Press the "Measurement" button to start the comparison.
Traverse the largest possible range until all edges are deleted from the "Collected positions"
diagram (line at 1).
Note
Traverse the largest possible measuring range!
Advertising