Casio YC-430 - Manual (Page 119)

119
PJ Camera Software Operating Environment
[Scanner] Tab
■ Operation Mode
Use this setting to select either [Auto] or [Manual] for the Scanner Mode.
[Auto]
When you place a document onto the PJ Camera Stand, PJ Camera Software automatically
records its image and saves it. This procedure is repeated whenever you replace the
document on the PJ Camera Stand with another one.
z Auto scanning automatically detects when the document on the document stage stops
moving and records its image. Even if you are still holding the document, auto scanning
will record its image if it detects that it has stopped moving. If auto scanning
automatically records the document before you are ready, remove the document and then
replace it onto the document stage to re-record it.
z Writing or other marks on the document stage can interfere with proper document
detection. Never write on the document stage and take care to guard against scratching
or otherwise damaging it.
[Manual]
With this setting, you need to perform a shutter release operation manually, and record the
image (document camera image) of the document on the PJ Camera Stand.
Configuring This Setting
Click [Auto] or [Manual]. This turns on (
) the clicked option and turns off ( ) the other
option.