Fostex VM200 - Manual (Page 100)

Monitoring Signals
100 VM200 User’s Guide
Monitoring
You can monitor the following sources: Stereo Buss, Rec Buss,
Aux1, Aux2, Aux3, Aux4, Eff1, Eff2, Aux 1&2, or Aux 3&4. (AUX 3
and 4 are available only when the ADD. AUX parameter is turned
on. For more information, see page 115.)
You can select a monitor source using the monitor select (Mon Sel)
parameter on the first
SYSTEM function page. Follow these steps:
1. Make sure a monitoring system (amp and speakers) is con-
nected to the MONITOR OUT jacks, or that stereo headphones
are connected to the PHONES jack. Also, make sure the 2TRK
IN switch is
not pressed in.
2. Set the Monitor Gain control to about halfway.
(For headphones, set the Phones Gain control to about halfway.)
3. Press the Setup [SYSTEM] key.
The VM200 displays the 1:CLOCK/MON function page.
4. Rotate the channel 3/4 (EQ/LO-MID) Gain rotary control to
select the desired source for the Mon Sel parameter.
5. Press the [CHANNEL/METER] or [EXIT] key.
The VM200 exits Setup mode and displays the CHANNEL EDIT func-
tion page.
MONITOR SELECT (MON. SEL.) PARAMETER OPTIONS
ST-B Stereo Buss (default setting)
REC-B Record Buss
AUX1 Auxiliary 1
AUX2 Auxiliary 2
AUX3 Auxiliary 3
AUX4 Auxiliary 4
EFF1 Effect processor EFF1
EFF2 Effect processor EFF2
AUX1&2 Auxiliary 1 and Auxiliary 2 mixed
AUX3&4 Auxiliary 3 and Auxiliary 4 mixed
EQ/HI EQ/HI-MID EQ/LO-MID EQ/LO
GAIN
FREQ
PAN
Q
PAN
FREQ Q FREQ Q FREQ Q
GAIN GAIN GAIN
PAN PAN PAN PAN PAN PAN