Fostex VM200 - Manual (Page 104)

Monitoring Signals
104 VM200 User’s Guide
Solo Safe Function
The VM200 features a Solo Safe function that enables you to desig-
nate specific channels as “solo safe.”
You can monitor solo safe channel signals that are sent to the stereo
buss regardless of the channel’s
[SOLO] key status. This function is
available when Solo Mode is set to M-Solo (see page 98).
1. Press the Setup [SYSTEM] key four times (from start of cycle).
The VM200 displays the SETUP:SYSTEM 4:SOLO SAFE function page. All
[EQ EDIT] keys flash.
2. Select the desired channel layer using the [1–8 ANALOG IN] ,
[9–16 ADAT IN] , and [17–20 EFF RTN] Page Select keys and press
the [EQ EDIT] key of the target channels.
The [EQ EDIT] keys of the solo safe channels light up, the [EQ
EDIT] keys of the non-solo safe channels continue to flash.
The boxes of the solo safe channels are highlighted (dark) on the
display.
In the example above, channels 5 & 6 are designated as “solo
safe” channels. In this case, pressing the channel 1
[SOLO] key in
M-Solo mode will enable you to monitor not only the channel 1
signal, but also the channels 5 & 6 signals from the stereo buss.
Other channels will be muted.
3. Press the [EXIT] key or the [CHANNEL/METER] key to return to
Channel Edit mode.