Fostex VM200 - Manual (Page 99)

Monitor Outs and Phones
VM200 User’s Guide 99
pressing the [SOLO] key for the desired channel.
Two Solo modes are available: PFL (Pre-Fader Listen) and M–SOLO
(Mix Solo).
See “Soloing” on page 101 for more information.
Monitor Outs and Phones
You can output Monitor and Solo signals via the MONITOR OUT and
PHONES jacks.
Make sure the 2TRK IN switch is not pressed in for monitoring (unless
you want to confidence monitor), or you will not hear a signal. (See
2TRK IN, below, for more information.)
You can connect a monitor system (amplifier and speakers) to the
MONITOR OUT phono jacks on the rear panel. You can use the Mon-
itor Gain control, located at the top right of the control surface, to
adjust the level of the monitor out signal.
You can connect a pair of stereo headphones to the PHONES stereo
(TRS) phone jack. The PHONES signal is the same as the MONITOR
OUT signal. You can adjust the level of the phones signal using the
Phones Gain control.
Two Track Input (2TRK IN)
If you press the 2TRK IN switch on the top panel, you can monitor
signals that are connected to the 2TRK IN jacks on the rear panel.
The signal is sent to the MONITOR OUT and PHONES jacks.
You can connect the stereo outputs of a master recorder, for exam-
ple, to the 2TRK IN jacks for confidence monitoring or master play-
back.
The 2TRK IN accepts phono jacks with a –10 dBV nominal input level.
MONITOR Gain
PHONES Gain
(top panel}
MIN MAX
GAIN
MAX MIN
GAIN
2TRK IN
PHONES MONITOR
2TRK IN jacks (rear panel)
2TRK IN switch
MIN MAX
GAIN
MAX MIN
GAIN
2TRK IN
PHONES MONITOR
R L
2TRK IN