Delay->reverb-type effects (42–45), Chorus-reverb (46) – Fostex VM200 User Manual
Page 144
Effects
144
VM200 User’s Guide
Delay->Reverb-type Effects (42–45)
CHORUS-REVERB (46)
Parameter
Value
Description
DELAY TIME
1–500 [ms] (1 step)
Delay time.
DELAY FB
0–100 [%] (1 step)
Amount of delay feedback.
DELAY BAL
0–100 [%] (1 step)
Delay sound level.
REV TIME
0.1–30.0 [s] (0.1 step)
Length of the reverberation.
PRE DLY
0–160 [ms] (1 step)
Delay time from the early reflections until the
reverb.
DENSITY
0–10, AUTO
1
1. With AUTO, the optimum value for the REV TIME setting will be used.
Density of the reverb.
DIFFUSION
0–100 [%] (1 step)
Left/right spread of the reverb effects.
LO RATIO
0.1–2.0 (0.1 step)
Length of the low frequency reverberation,
expressed as a ratio relative to the REV.TIME.
HI RATIO
0.1–1.0 (0.1 step)
Length of the high frequency reverberation,
expressed as a ratio relative to REV.TIME.
LPF
1.00kHz–20.2kHz, THRU
(step: same as EQ)
Cut-off frequency of the low pass filter.
PRESENCE
-10–0–+10 (1 step)
2
2. Brightness increases with a positive setting, and decreases with a negative setting.
Brightness in the high range of the reverb.
Parameter
Value
Description
CHO DEPTH
0–100 [%] (1 step)
Modulation depth.
REV TIME
0.1–30.0 [s] (0.1 step)
Length of the reverberation.
PRE DLY
0–160 [ms] (1 step)
Delay time from the early reflections until the
reverb.
HI RATIO
0.1–1.0 (0.1 step)
Length of the high frequency reverberation,
expressed as a ratio relative to REV.TIME.
PRESENCE
-10–0–+10 (1 step)
1
1. Brightness increases with a positive setting, and decreases with a negative setting.
Brightness in the high range of the reverb.
DENSITY
0–10, AUTO
2
2. With AUTO, the optimum value for the REV TIME setting will be used.
Density of the reverb.
LPF
1.00kHz–20.2kHz, THRU
(step: same as EQ)
Cut-off frequency of the low pass filter.
REV BAL
0–100 [%] (1 step)
Level of reverb sound.