Fostex VM200 - Manual (Page 81)

Resetting the EQ
VM200 User’s Guide 81
The EQ On/Off indicator in the lower-right corner of the display
displays “On” to indicate that the EQ is turned on for the specified
channel.
4.
To turn the EQ off for the channel, press the [EQ ON] key
again.
The [EQ ON] key turns off (goes dark), and the VM200 turns off the
EQ for the selected channel.
The EQ On/Off indicator in the lower-right corner of the display
displays “Off” to indicate that the EQ is turned off for the specified
channel.
Resetting the EQ
To reset all EQ parameters for the selected channel to their initial val-
ues, follow the steps below.
The following table shows initial EQ values.
1.
Press the [EQ EDIT] key of the channel whose EQ you wish to
reset to the initial value.
The [EQ EDIT] key lights up and the EQ EDIT function page appears.
2.
While pressing and holding down the [ENTER] key, press the
[EQ EDIT] key.
The following confirmation dialog appears on the display.
3.
Press the [ENTER] key to proceed, or press the [EXIT] key to
cancel the reset operation.
Lo Lo-Mid Hi-Mid Hi
Gain (G) 0 dB 0 dB 0 dB 0 dB
Frequency (F) 125 Hz 500Hz 2.00 kHz 8.00 kHz
Q L-S(Lo-Shelf) 1.0 1.0 H-S(Hi-Shelf)
EQ On/Off indicator. Here, EQ is bypassed.