Fostex VM200 - Manual (Page 202)

202 VM200 User’s Guide
Display Warning Messages
Warning Messages Meaning
EQ 1–8 Invalid! (EQ Enable 9–16)
The EQ ENABLE setting of the channel you are operating is
not turned ON, thus the EQ is not available for that channel.
EQ 9–16 Invalid! (EQ Enable 1–8)
The EQ ENABLE setting of the channel you are operating is
not turned ON, thus the EQ is not available for that channel.
Channel Invalid!
You have tried to operate channels 21–24, which are not
available.
AUX 3/4 Invalid! (ADD.AUX Off)
ADD AUX parameter is turned off, and AUX3/4 are not avail-
able.
REC BUSS Invalid! (AD.AUX On)
ADD AUX parameter is turned on, and REC BUSS is not
available.
EFF 1/2 Invalid! (EQ Enable
1–16) EQ is enabled for channels 1–16, and effects are not avail-
able.
+48V SW On!
The phantom power is turned on. (This appears when pow-
ering up the mixer.)
Byte Count Error in BULK DATA!
The byte count of the received Bulk Dump data is not cor-
rect.
Check Sum Error in BULK DATA!
The check sum of the received Bulk Dump data is not cor-
rect.
MIDI IN Buffer Full! The VM200 has received too much MIDI data.
MIDI OUT Buffer Full! The VM200 has transmitted too much MIDI data.
Wrong WORD-IN CLK
The word clock received from the connected device is not
correct and the VM200 cannot synchronize correctly.
Wrong ADAT-IN CLK!
Digital signals from the ADAT IN connector are not word
clock synchronized with the VM200, and noise may infiltrate
the audio data.
Wrong S/P DIF-IN CLK!
Digital signals from the S/P DIF-IN connector are not word
clock synchronized with the VM200, and noise may infiltrate
the audio data.