Fostex VM200 - Manual (Page 143)

Effects Parameters
VM200 User’s Guide 143
MONO_PITCH (40)
DUAL_PITCH (41)
LPF
1.00kHz–20.2kHz, THRU
(step: same as EQ)
Cut-off frequency of the low pass filter.
1. Brightness increases with a positive setting, and decreases with a negative setting.
Parameter Value Description
PITCH
-24–0–+24 (1 step)
(+/-2 octave)
Amount of pitch shift.
ADJUST
-100–0–+100 (1 step)
(+/- semitone)
Fine adjustment to the pitch shift.
PITCH DLY 0–340 [ms] (1 step) Delay time of the pitch shift.
PITCH FB 0–100 [%] (1 step) Feedback amount.
PITCH PAN
L10.0–0.0–R10.0 (0.5
step)
Pan position of the pitch shift.
PITCH MODE 1, 2, 3, 4 1
1. Select “1” when response speed is priority. Select “2” for a typical setting. Select “3” or
“4” for more clarity.
Selects the size of the buffer for pitch shift.
Parameter Value Description
PITCH1/2
-24–0–+24 (1 step)
(+/-2 octave)
Amount of pitch shift for PITCH SHIFT 1 or 2.
ADJUST1/2
-100–0–+100 (1 step)
(+/- semitone) Fine adjustment to the pitch shift for PITCH
SHIFT 1 or 2.
PIT1/2 DLY 0–340 [ms] (1 step)
Delay time of the pitch shift for PITCH SHIFT 1 or
2.
PIT1/2 FB 0–100 [%] (1 step) Feedback amount for PITCH SHIFT 1 or 2.
PIT1/2 PAN
L10.0–0.0–R10.0 (0.5
step)
Pan position of PITCH SHIFT 1 or 2.
PIT1/2 MODE
1, 2, 3, 4
1
1. Select “1” when response speed is priority. Select “2” for a typical setting. Select “3” or
“4” for more clarity.
Selects the size of the buffer for PITCH SHIFT 1
or 2.
Parameter Value Description