Fostex VM200 - Manual (Page 24)

Touring the VM200
24 VM200 User’s Guide
Current Scene Status
The Current Scene Status section features only one key, which
shares its name.
When you press the [CURRENT SCENE STATUS] key, the VM200 enters
Current Scene Status mode and displays the CURRENT SCENE STATUS
function page. The number and name of the scene (e.g.,
01:MY_SCENE ) appear in the top right of the display.
The CURRENT SCENE STATUS function page enables you to:
• Enable the EQ for channels 1-8, 9-16, or 1-16
• Turn on the ADD. AUX parameter (to enable AUX Sends 3&4)
• Set the Smoothing function to Level 1 or 2
• Set the record buss gain (REC-B.GAIN) from [
∞
to -90 to 0dB]
(available when ADD. AUX is off)
• Set the sends for AUX1, AUX2, AUX3, and AUX4, EFF1, and EFF2
to Pre-fader or Post-fader
• Pair AUX Sends (Aux1&2 or Aux3&4).
Key Mode Section
The Key Mode section features four function keys: [ROUT-
ING/PHASE] , [PAIR/GROUP] , [CH VIEW] , and [CHANNEL/METER] , as
described below.
[ROUTING/PHASE] Key
The [ROUTING/PHASE] key displays a sequence of three function
pages that let you control mixer routing, assign S/P DIF inputs to
channels, and invert the phase for each channel.
The ROUTING function page lets you route input channels 1–20 to the
Stereo Buss (ST BUS), the Record Buss (REC BUS), or the ADAT out-
put (DIRECT).
Press a Page Select key to specify Channels 1-8, 9-16, or 17-20. Then
press the
[EQ EDIT] , [SOLO] , and/or [ON] key for each channel to route
the signal to a potential destination. The indicator in the chan-
nel/buss matrix highlights (dark square).
CURRENT SCENE STATUS
KEY MODE
PHASE GROUP
ROUTING/ PAIR/
CH VIEW METER
CHANNEL/
MMC SEND