Fostex VM200 - Manual (Page 101)

Soloing
VM200 User’s Guide 101
Soloing
A Solo function is available for input channels 1 through 20 that
enables you to monitor specific channels.
Two solo modes are available: PFL and M-Solo.
PFL is an abbreviation for Pre-Fader Listen, in which you can monitor
a signal that appears before it is adjusted by the fader.
M-Solo means “mix solo,” which enables you to momentarily monitor
the stereo buss signal (i.e., the mix).
You can select a solo mode by using the Solo Mode parameter on the
first
SETUP:SYSTEM function page.
You can also control how [SOLO] keys are turned on and off.
To use the Solo function, follow the steps below:
1. Make sure a monitoring system (amp and speakers) is con-
nected to the MONITOR OUT jacks, or that stereo headphones
are connected to the PHONES jack. Also, make sure the 2TRK
IN switch is
not pressed in.
2. Set the Monitor Gain control to about halfway.
(If you are using headphones, set the Phones Gain control to
about halfway.)
3. Press the Setup [SYSTEM] key.
The VM200 displays the 1:CLOCK/MON function page.
4. Rotate the channel 5/6 (EQ/HI-MID) Gain rotary control to
select the desired Solo Mode.
SOLO MODE PARAMETER OPTIONS
PFL Pre-Fader Listen mode (default setting)
M-SOLO Mix-solo mode
EQ/HI EQ/HI-MID EQ/LO-MID EQ/LO
GAIN
FREQ
PAN
Q
PAN
FREQ Q FREQ Q FREQ Q
GAIN GAIN GAIN
PAN PAN PAN PAN PAN PAN