Fostex VM200 - Manual (Page 113)

Soloing the REC BUSS OUT
VM200 User’s Guide 113
Soloing the REC BUSS OUT
You can solo the signal output from the REC BUSS by pressing the
REC BUSS
[SOLO] key (located next to the Master [SOLO] key). The
Rec Buss [SOLO] key lights up. The Rec Buss [SOLO] key works only
when Solo mode is set to PFL, which is the default setting. If Solo
mode is set to M-Solo, the Rec Buss
[SOLO] key is disabled. For more
information on Solo mode, see page 101.
If you set the Solo Key parameter to LATCH, pressing the Rec Buss
[SOLO] key solos the stereo output until you press the Rec Buss [SOLO]
key again. If the parameter is set to UNLATCH, the Rec Buss output
will solo only until you release the Rec Buss
[SOLO] key.
Setting the REC BUSS OUT Level
You can set the Rec Buss output level on the CURRENT SCENE STATUS
function page.
1.
Press the [CURRENT SCENE STATUS] key.
The VM200 displays the CURRENT SCENE STATUS function page.
2.
Rotate the EQ/HI Gain rotary control (channels 7/8) to adjust
the REC-B GAIN parameter.
The REC-B GAIN parameter controls the Rec Buss Out level.
REC BUSS
SOLO
REC BUSS SOLO key