Fostex VM200 - Manual (Page 117)

Sending Channel Signals to AUX Sends
VM200 User’s Guide 117
Sending Channel Signals to AUX Sends
You can send signals from input channels 1 through 20 to AUX Sends
1 through 4.
If the AUX Send is configured post-fader (see “Pre-fader/Post-fader
AUX Sends” below), first raise the channel’s regular fader l prior to
step 1 by pressing the
[CHANNEL] button, and then raising the fader.
1.
In the Fader Mode section, press the [AUX1], [AUX2], [AUX3] , or
[AUX4] key to select an AUX Send.
The faders now function as channel AUX Send controls for the
selected AUX Send.
2.
Raise the fader of the channel you want to send to the AUX
Send.
3.
Use the Master fader to adjust the AUX Sends master level.
When channels are configured as stereo pairs their AUX Send
controls are linked. (See “Pairing Channels” on page 68).
Pre-fader/Post-fader AUX Sends
You can configure each AUX Send as pre-fader or post-fader by
adjusting parameters on the
CURRENT SCENE STATUS function page.
Pre-fader signals do not pass through the channel faders and are
therefore unaffected by channel fader settings. Post-fader signals
pass through the channel faders and are affected by channel fader
settings.
Follow these steps to configure each AUX Send as pre-fader or
post-fader.
1.
Press the [CURRENT SCENE STATUS] key.
The VM200 displays the CURRENT SCENE STATUS function page.
Note: If the ADD. AUX parameter is on, the REC BUSS is disabled. Fore
more information, see “Enabling AUX Sends 3 & 4 (ADD. AUX Parame-
ter)” on page 115.
Note: If the Smoothing function is set to Level 2 (default), AUX1 and EFF1
are linked, and AUX2 and EFF2 are linked. Therefore, setting the AUX1
level also sets EFF1 to the same level; similarly, setting the AUX2 level
sets EFF2 to the same level. If the Smoothing function is set to Level 1,
you may hear a slight stepping noise when you move the fader. For more
information on the Smoothing function, see “Smoothing Function” on
page 120.
pre-fader/post-fader AUX Sends