Fostex VM200 - Manual (Page 80)

EQ
80 VM200 User’s Guide
EQ Enabling Channels
You can enable the EQ for three groups of channels: 1–8, 9–16, or
1–16.
(The default setting enables the EQs for channels 1–8.)
1. Press the [CURRENT SCENE STATUS] key.
The CURRENT SCENE STATUS function page appears. Notice the EQ
Enable parameter in the upper-left corner.
2. Turn the channel 1/2 Gain rotary control to select 1–8, 9–16,
or 1–16 for the EQ Enable parameter.
The selected value flashes.
3. Press the [ENTER] key to confirm your selection.
The VM200 displays the selected value for the EQ Enable param-
eter.
4.
Press the [EXIT] key or the [CHANNEL/METER] key to return to
Channel Edit mode.
Bypassing the EQ
You can turn a channel’s EQ on or off (bypass) using the [EQ ON]
key.
While the target channel is selected (by pressing a Page Select key
and the channel’s
[EQ EDIT] key), press the [EQ ON] key to toggle
between EQ On and Off.
When the EQ is on, a highlighted “ON” indicator appears in the
lower-right corner of the
EQ EDIT function page. If the EQ is bypassed,
“OFF” appears in the same location.
1. Press the [1–8 ANALOG IN] or [9–16 ADAT IN] Page Select key to
select a channel layer.
The selected Page Select key lights up.
2.
Press the [EQ EDIT] key for the channel whose EQ you wish to
turn on or off.
The selected [EQ EDIT] key lights up and the VM200 displays the
EQ EDIT function page.
3.
Press the [EQ ON] key in the Selected EQ section.
The [EQ ON] key lights up, and the VM200 turns on the EQ for the
selected channel.