Fostex VM200 - Manual (Page 195)

Storing Locate Points
VM200 UserÕs Guide 195
Storing Locate Points
Follow the steps below to store a locate point to the desired Locate
key.
1.
While the MMC SEND function page is displayed, rotate the
[GAIN] rotary controls to set the locate times in hours, min-
utes, seconds, and frames.
The EQ/LO GAIN rotary control adjusts the hours (MTC-[h]).
The EQ/LO-MID GAIN rotary control adjusts the minutes
(MTC-[m]).
The EQ/HI-MID GAIN rotary control adjusts the seconds (MTC-[s]).
The EQ/HI GAIN rotary control the frames (MTC-[f]).
2.
Press the channel 8 [ON] key (functioning as the STORE key),
then press an [EQ EDIT] or [SOLO] key to specify where you
wish to store the locate point.
The VM200 displays the locate point in the upper-left of the dis-
play.
Checking the Locate Points
You can check the locate points memorized into the Locate keys as
follows:
3. While the MMC SEND function page is displayed, press the chan-
nel 7 [ON] key (functioning as the RECALL key), then press the
Locate key for the Locate point you wish to check.
The VM200 displays the locate point in the upper-left of the dis-
play.
Transmitting the Locate Commands
4.
Press the desired [EQ EDIT] or [SOLO] keys 1–16 (functioning as
Locate keys 1–16) to transmit the locate commands to the
recorder.
Note that you can store Locate points using the MIDI Bulk Dump
function. See “Bulk Dump” on page 189.
LOCATE TIME LOCATE POINT