Fortinet MR1 - Manual (Page 116)

116
5.2.7.2 storm-control broadcast
This command enables broadcast storm recovery mode on the selected interface. If the
mode is enabled, broadcast storm recovery with high threshold is implemented. The
threshold implementation follows a percentage pattern. If the broadcast traffic on any
Ethernet port exceeds the high threshold percentage (as represented in “Broadcast Storm
Recovery Thresholds” table) of the link speed, the switch discards the broadcasts traffic until
the broadcast traffic returns to the threshold percentage or less. The full implementation is
depicted in the “Broadcast Storm Recovery Thresholds” table.
Syntax
storm-control broadcast
no storm-control broadcast
no - This command disables broadcast storm recovery mode on the selected interface. The threshold
implementation follows a percentage pattern. If the broadcast traffic on any Ethernet port exceeds the
high threshold percentage (as represented in “Broadcast Storm Recovery Thresholds” table) of the link
speed, the switch discards the broadcasts traffic until the broadcast traffic returns to the threshold
percentage or less. The full implementation is depicted in the “Broadcast Storm Recovery Thresholds”
table.
Default Setting
Disabled
Command Mode
Interface Config
This command enables broadcast storm recovery mode on all interfaces.
Syntax
storm-control broadcast
no storm-control broadcast
no - This command disables broadcast storm recovery mode on all interfaces.
Default Setting