Fortinet MR1 - Manual (Page 358)

358
6.6.1.2 show ip rip interface
This command displays information related to a particular RIP interface.
Syntax
show ip rip interface <slot/port>
< slot/port > - Interface number
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface: Valid slot and port number separated by a forward slash. This is a configured value.
IP Address: The IP source address used by the specified RIP interface. This is a configured value.
Send version: The RIP version(s) used when sending updates on the specified interface. The types are
none, RIP-1, RIP-1c, and RIP-2. This is a configured value.
Receive version: The RIP version(s) allowed when receiving updates from the specified interface. The
types are none, RIP-1, RIP-2, Both. This is a configured value.
RIP Admin Mode: RIP administrative mode of router RIP operation; enable, disable it. This is a configured
value.
Link State: Indicates whether the RIP interface is up or down. This is a configured value.
Authentication Type: The RIP Authentication Type for the specified interface. The types are none, simple,
and encrypt. This is a configured value.
Authentication Key: 16 alpha-numeric characters for authentication key when uses simple or encrypt
authentication.
Authentication Key ID: It is a Key ID when uses MD5 encryption for RIP authentication.
Default Metric: A number which represents the metric used for default routes in RIP updates originated on
the specified interface. This is a configured value. The following information will be invalid if the link state is
down.
Bad Packets Received: The number of RIP response packets received by the RIP process which were
subsequently discarded for any reason.
Bad Routes Received: The number of routes contained in valid RIP packets that were ignored for any
reason.
Updates Sent: The number of triggered RIP updates actually sent on this interface.
6.6.1.3 show ip rip interface brief
This command displays general information for each RIP interface. For this command to
display successful results routing must be enabled per interface (i.e. ip rip).