Fortinet MR1 - Manual (Page 137)

137
5.3.3.4 exec-timeout
This command sets the remote connection session timeout value, in minutes. A session is
active as long as the session has been idle for the value set. A value of 0 indicates that a
session remains active indefinitely. The time is a decimal value from 0 to 160.
Note: Changing the timeout value for active sessions does not become effective until the
session is reaccessed. Any keystroke will also activate the new timeout duration.
Syntax
exec-timeout <1-160>
no exec-timeout
<sec> - max connect time (Range: 1 -160).
no - This command sets the remote connection session timeout value, in minutes, to the default.
Note: Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Any keystroke will also activate the new timeout duration.
Default Setting
5
Command Mode
Telnet Config
5.3.3.5 password-threshold
This command is used to set the password instruction threshold limited for the number of
failed login attempts.
Syntax
password-threshold <0-120>
no password-threshold
<threshold> - max threshold (Range: 0 - 120).
no - This command sets the maximum value to the default.
Default Setting