Fortinet MR1 - Manual (Page 30)

30
2.3 Quick Starting the Switch
1. Read the device Installation Guide for the connectivity procedure. In-band
connectivity allows access to the FortiSwitch- 100 switch locally or from a remote
workstation. The device must be configured with IP information (IP address, subnet
mask, and default gateway).
2. Turn the Power ON.
3. Allow the device to load the software until the login prompt appears. The device
initial state is called the default mode.
4. When the prompt asks for operator login, do the following:
• Type the word admin in the login area. Since a number of the Quick Setup
commands require administrator account rights, Fortinet suggests logging
into an administrator account.
• Do not enter a password because there is no password in the default mode.
• Press the <Enter> key
• The CLI Privileged EXEC mode prompt will be displayed.
• Use “configure” to switch to the Global Config mode from Privileged EXEC.
• Use “exit” to return to the previous mode.
2.4 System Information Setup
2.4.1 Quick Start up Software Version Information
Table 2-1. Quick Start up Software Version Information
Command Details
show hardware Allows the user to see the HW & SW version
the device contains
System Description - switch's model name
show switch Burned in MAC address - MAC address
assigned to this switch CPU
2.4.2 Quick Start up Physical Port Data
Table 2-2. Quick Start up Physical Port
Command Details