Fortinet MR1 - Manual (Page 173)

173
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The Configuration Identifier Revision Level is
a number in the range of 0 to 65535.
Syntax
spanning-tree configuration revision <0-65535>
no spanning-tree configuration revision
<value> - Revision Level is a number in the range of 0 to 65535.
no - This command sets the Configuration Identifier Revision Level for use in identifying the configuration
that this switch is currently using to the default value, that is, 0.
Default Setting
0
Command Mode
Global Config
5.4.2.4 spanning-tree mode
This command sets the Force Protocol Version parameter to a new value. The Force
Protocol Version can be one of the following:
1. stp - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d functionality supported)
2. rstp - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w functionality supported)
3. mstp - MST BPDUs are transmitted (IEEE 802.1s functionality supported)
Syntax
spanning-tree mode {stp | rstp | mstp}
no spanning-tree mode
no - This command sets the Force Protocol Version parameter to the default value, that is, mstp.
Default Setting
mstp