Fortinet MR1 - Manual (Page 214)

214
server-timeout: Sets the value, in seconds, of the timer used by the authenticator state
machine on this port to timeout the authentication server. The supp-timeout must be a value
in the range 1 - 65535.
Syntax
dot1x timeout {quiet-period | reauth-period | server-timeout | supp-timeout | tx-period}
<seconds>
no dot1x timeout {quiet-period | reauth-period | server-timeout | supp-timeout | tx-period}
<seconds> - Value in the range 0 – 65535.
no - This command sets the value, in seconds, of the timer used by the authenticator state machine on
this port to the default values. Depending on the token used, the corresponding default values are set.
Default Setting
reauth-period: 3600 seconds
quiet-period: 60 seconds
tx-period: 30 seconds
supp-timeout: 30 seconds
server-timeout: 30 seconds
Command Mode
Interface Config
5.8.4 Radius Configuration Commands
5.8.4.1 radius accounting mode
This command is used to enable the RADIUS accounting function.
Syntax
radius accounting mode
no radius accounting mode