Fortinet MR1 - Manual (Page 232)

232
5.10.2 Configuration Commands
5.10.2.1 sntp broadcast client poll-interval
This command will set the poll interval for SNTP broadcast clients in seconds as a power of
two where <poll-interval> can be a value from 6 to 16.
Syntax
sntp broadcast client poll-interval <6-10>
no sntp broadcast client poll-interval
<6-10> - The range is 6 to 16.
no - This command will reset the poll interval for SNTP broadcast client back to its default value.
Default Setting
6
Command Mode
Global Config
5.10.2.2 sntp client mode
This command will enable Simple Network Time Protocol (SNTP) client mode and optionally
setting the mode to either broadcast, multicast, or unicast.
Syntax
sntp client mode [broadcast | unicast]
no sntp client mode
no - This command will disable Simple Network Time Protocol (SNTP) client mode.