Fortinet MR1 - Manual (Page 342)

342
6.3.2.30 ip ospf hello -interval
This command sets the OSPF hello interval for the specified interface.
Syntax
ip ospf hello-interval <1-65535>
no ip ospf hello-interval
< 1-65535 > - Is a valid positive integer, which represents the length of time in seconds. The value for
the length of time must be the same for all routers attached to a network.
<no> - This command sets the default OSPF hello interval for the specified interface.
Default Setting
The default hello interval is 10 seconds.
Command Mode
Interface Config
6.3.2.31 ip ospf priority
This command sets the OSPF priority for the specified router interface
Syntax
ip ospf priority <0-255>
no ip ospf priority
< 0-255 > - The range of the priority value is 0 to 255. A value of '0' indicates that the router is not eligible
to become the designated router on this network.
<no> - This command sets the default OSPF priority for the specified interface.
Default Setting
The default priority value is 1. It is the highest router priority.
Command Mode