FUJITSU INTEGRATED REMOTE MANAGEMENT CONTROLLER IRMC S2/S3 - Manual (Page 246)

246 iRMC S2/S3
Network Settings - Configure the LAN parameters
Ports for web-based access
Session Timeout
Period of inactivity (in seconds) after which the session is automatically
closed. The login page of the iRMC S2/S3 web interface then appears,
and you can log in again as required (see
page 136 ).
I
Your session will not automatically be closed if it is inactive when
the time specified in
Session Timeout has elapsed if you enter a
value for the refresh interval which is less than the Session Timeout
in the Refresh every ... seconds field (see page 247 ).
HTTP Port
HTTP port of the iRMC S2/S3
Default port number: 80
Configurable: yes
Enabled by default: yes
Communication direction: inbound and outbound
HTTPS Port
HTTPS (HTTP Secure) port of the iRMC S2/S3
Default port number: 443
Configurable: yes
Enabled by default: yes
Communication direction: inbound and outbound
Force HTTPS
If you enable the Force HTTPS option, users can only establish a secure
connection to the iRMC S2/S3 on the HTTPS port specified in the entry
field.
If you disable the Force HTTPS option, users can establish a non-secure
connection to the iRMC S2/S3 on the HTTP port specified in the entry
field.
I
If the SSL certificate has expired, a message to this effect is
issued in the browser.
Enable Auto Refresh
If you activate this option, the contents of the iRMC S2/S3 web interface
are automatically refreshed periodically. Specify the refresh interval in
the
Refresh every ... seconds field.