FUJITSU INTEGRATED REMOTE MANAGEMENT CONTROLLER IRMC S2/S3 - Manual (Page 83)

iRMC S2/S3 83
Local user management for the iRMC S2/S3
I
Although this file contains no security-critical information, read/write
permission should only be granted to the owner. Access should be
denied to all other users.
3. System-wide configuration file ( /etc/ssh/ssh_config )
This file contains default values for configuration parameters
– if there is no user-specific configuration file or
– if the relevant parameters are not specified in the user-specific
configuration file.
The value found first applies for each option.
I
You will find detailed information on the configuration of ssh and on its
operands on the manual pages for OpenSSH under
http://www.openssh.org/manual.html
Proceed as follows:
Ê Start ssh , to log in to the iRMC S2/S3 under SSHv2-authentication:
ssh -l [<user>] <iRMC_S2/S3>
or
ssh [<user>@]<iRMC_S2/S3>
<user>
User name under which you want to log into the iRMC S2/S3. If you
do not specify <user>,
ssh uses the user name under which you are
logged into your local computer to log you in to iRMC S2/S3.
<iRMC_S2/S3>
iRMC S2/S3 name or IP address of the iRMC S2/S3 you want to log
into.
Example: SSHv2-authenticated login on the iRMC S2/S3
For the following ssh - call, it is assumed that ssh-keygen has been used to
generate a public/private RSA key pair as described under "Example:
Generating an RSA key pair with ssh -keygen" on page 75 and that the
public key User1/.ssh/id_rsa.pub has been loaded onto the iRMC S2/S3 for an
iRMC S2/S3 user user4 (see page 77 ).
You can then log in from your local computer under $HOME/User1 as follows
on the iRMC S2 "RX100_S52-iRMC" using the login user4 :