FUJITSU INTEGRATED REMOTE MANAGEMENT CONTROLLER IRMC S2/S3 - Manual (Page 47)

iRMC S2/S3 47
Configuring the LAN interface of the iRMC S2/S3
Ê Configure the following settings:
Management LAN
Set the value to Enabled .
Management LAN Port
The Management setting is recommended.
I
For details on configuring the remaining settings see section
"Network Settings - Configure the LAN parameters" on page 238
and/or refer to the manual "BIOS (Aptio) Setup Utility" manual
corresponding to your server.
Ê Save the settings.
Ê If you want to use console redirection on the iRMC S3, continue with section
"Configuring text console redirection for the iRMC S3" on page 53 .
If you do not want to use text console redirection on the iRMC S3, exit the
UEFI setup and continue with the next
section "Testing the LAN interface" .
3.1.4 Testing the LAN interface
You can test the LAN interface as follows:
Ê Use a web browser to attempt to log into the iRMC S2/S3 web interface. If
no login prompt appears, it is probable that the LAN interface is not working.
Ê Test the connection to the iRMC S2/S3 with a ping command.