FUJITSU INTEGRATED REMOTE MANAGEMENT CONTROLLER IRMC S2/S3 - Manual (Page 415)

iRMC S2/S3 415
Configuring the iRMC S2/S3 via SCCI and scripted configuration
Parameters of SCCI provider-specific commands
The following SCCI-provider-specific commands are available:
Operation Code ( OC )
Hex value or string specifying the command / operation code.
I
The iRMC S2/S3 only supports a limited set of SCCI commands.
For a list of supported commands see
table "SCCI commands
supported by the iRMC S2/S3" on page 420
Operation Code Extension ( OE )
Hex value for extended operation code. Default: OE=0
For ConfigSpace Read-/Write operations, this value defines the
ConfigSpace ID.
Object Index ( OI )
Hex value selecting an instance of an object. Default:OI=0"
Operation Code Type ( Type )
For configuration settings, the values GET (read operation) and SET (write
operation) are supported. Default: Type=GET
I
SET operations require data. For specifying the appropriate data
type, use the Data (DATA) parameter described below.
Cabinet Identifier ( CA )
Allows you to select an extension cabinet and use its cabinet ID number.
I
Do not use this parameter to request for the system cabinet!
Data ( DATA )
If a SET parameter (write operation) is specified: Data type ( Type
parameter), and, in some cases, data length ( LEN parameter) are
required.
Currently, the following data types are supported:
– xsd::integer
Integer value
Example
<DATA Type="xsd::integer">1234</DATA>