4 engine, 1 engine toner empty, 2 energy saver – Konica Minolta Magicolor 5440 DL User Manual

Page 117: 3 auto continue, 4 tray chaining, Engine -14, Engine toner empty -14, Energy saver -14, Auto continue -14, Tray chaining -14

Advertising
background image

Menu (magicolor 5430 DL /5440 DL)

Main Unit Field Service

3-14

III

Ad

just

men

t/Set

ting

4.4

ENGINE

4.4.1

ENGINE TONER EMPTY

4.4.2

ENERGY SAVER

4.4.3

AUTO CONTINUE

4.4.4

TRAY CHAINING

Function

• Specifies whether to stop or continue printing when a toner empty condition is

detected.

Use

• To specify whether to permit printing upon a toner empty condition.

Setting
/procedure

• The setting can be changed during printing.
• The default setting is “STOP.”

STOP

CONTINUE

Function

• Sets the amount of time before the machine enters Energy Saver mode after the last

print is received or the last key operated.

• The Energy Saver mode is automatically canceled when any of the following opera-

tions is performed:

The machine is restarted.
A print job is received.
Any of the keys on the Control Panel is pressed.
The Front Door or Right Door is opened and closed.
A Tray is opened, then closed.

Use

• To change the amount of time before the machine enters Energy Saver mode.

Setting
/procedure

• The default setting is “30 MINUTES.”

15 MINUTES

30 MINUTES

1 HOUR

2 HOURS

Function

• Enables or disables printing when the size of the media loaded in the tray does not

match that of the print data.

Use

• To select whether to print data on media of another size when the size of the media

loaded in the tray does not match that of the print data.

Setting
/procedure

• The setting can be changed during printing; however, the change is applied begin-

ning with the next job.

• The default setting is “ON.”

ON

OFF

Function

• Enables or disables printing when the current tray runs out of media during the print

cycle by automatically selecting another one loaded with the media of the same size
and type.

• The setting is available only when an optional Lower Feeder Unit is installed.

Use

Setting/
procedure

• The setting can be changed during printing; however, the change is applied begin-

ning with the next job.

• The default setting is “ON.”

ON

OFF

5450_E.book_PDF.book 14 ページ 2005年4月12日 火曜日 午後12時54分

Advertising