Konica Minolta Magicolor 5440 DL - Manual (Page 127)

Service Mode (magicolor 5430 DL/5440 DL) Main Unit Field Service
3-24
III
Ad
just
men
t/Set
ting
5.3.2 SERVICE PERSON SRU USAGE
5.3.3 RESET CONTROLLER
Use
Setting
/procedure 1. Take note of the current setting.
2. Enter the Service/Service Person mode.
3. Select RESTORE FACTORY DEFAULT and press the MENU/SELECT key.
4. When the initialization procedure is completed, restart the machine.
5. Make the settings that were valid before initialization once again.
NOTE
• Use this function with the greatest possible care. If this function is executed,
the setting/count values saved in the Parameter Chip on the Mechanical Con-
trol Board are cleared.
• After executing this function, replace the following items with new ones:
All 4 Toner Cartridges
Transfer Roller
Transfer Belt
Fusing Unit
Waste Toner Bottle
*2: XXXXXX are the last 6 digits of the printer MAC address.
Item Factory Default Value Ref. Page
PageScope
Web Connection
Primary WINS grayout/disabled -
Secondary WINS grayout/disabled -
Rendezvous Service
Discovery
Checked -
Rendezvous Config
Printer Name
KONICA MINOLTA
magicolor 54** DL
-
Rendezvous Config
Host Name
MC54**DLXXXXXX *2 -
IPP Config
Printer Name
magicolor 54** DL -
IPP Config
Printer Location
Blank -
Function • Displays the remaining life of the Transfer Belt, Transfer Roller, and Fusing Unit.
Use • To check the remaining life of the maintenance service parts.
Setting
/procedure 1. Enter the Service mode.
2. Select SERVICE PERSON SRU USAGE and press the MENU/SELECT key.
3. Select the desired unit using the right and left arrow keys.
Function • Resets the controller.
Use • To return the controller to its initial condition.
Setting
/procedure 1. Enter the Service mode.
2. Select RESET CONTROLLER and press the MENU/SELECT key.
3. This automatically restarts the machine and the initial screen reappears.
5450_E.book_PDF.book 24 ページ ２００５年４月１２日 火曜日 午後１２時５４分