Konica Minolta Magicolor 5440 DL - Manual (Page 60)

Main Unit Field Service Firmware Upgrade
2-23
II Main
tena
nce
3.1.2 Upgrade procedure (magicolor 5450)
A. How to upgrade using the Network Interface
1. Connect the machine to the PC using an Ethernet cable.
NOTE
• For connections via a HUB, use a straight cable.
• For direct connections between the printer and PC, use the crossover cable.
• For PCs that support 1000BASE-T (Gigabit Ethernet), use a 1000BASE-T-enabled
Ethernet cable (over category 5e.) If a cable that is not compatible with
1000BASE-T is used, communication may not be made correctly.
• Check that printing is available over the network.
2. From the Menu, select PRINT MENU → CONFIGURATION PG and execute the func-
tion. Then, check the IP address [1] of the machine.
☞ For how to execute “CONFIGURATION PG,” see “III Adjustment/Setting.”
3. Copy the firmware data and upgrading program to any directory on the PC.
4. Start the Command Prompt and go to the directory in which the firmware data is
stored.
5. Execute the following command to start the transfer of the firmware data to the printer.
(The screen shown below indicates that the firmware data resides on the C drive.)
[1]
4138F2E003DA
Data to be upgraded Command
FW upgraded data > lpr -S XXX.XXX.XXX.XXX -P lp -o l 4138**********.prn
XXX.XXX.XXX.XXX : IP address of the machine
******
: File name of FW upgrade data
4138F2E004DA
5450_E.book_PDF.book 23 ページ ２００５年４月１２日 火曜日 午後１２時５４分