YSI IQ SensorNet 2020 XT Terminal - Manual (Page 79)

System 2020 XT USB Operation
4 - 1 ba76019e01 12/2012
4 Operation
4.1 MIQ/TC 2020 XT terminal/controllers
During the initial commissioning of the MIQ/TC 2020 XT, a query
appears asking you in which function you want to use the MIQ/
TC 2020 XT in the system.
Two configurations can be selected:
 Configuration as terminal and controller
 Configuration as a mobile terminal
The MIQ/TC 2020 XT (configured as terminal/controller) is the
operating and control unit of the IQ S
ENSOR N ET .
You can install further terminal components:
 MIQ/TC 2020 XT (configured as terminal)
(more compatible terminals, see section 1.4)
 MIQ/IF232 interface component with software terminal (see MIQ/
IF232 component operating manual)
The terminal can be used to:
 Display measurement results
 Start calibration
 Perform system and terminal settings
 Display messages.
Note
To guarantee data safety within the IQ S
ENSOR N ET , access to the
following functions is only possible from one terminal at the same time:
 Opening the Settings menu
 Start calibration
 Assigning IQ sensors or MIQ output modules as substitutes.
If one of these functions is already active at another terminal, a note
appears on the display.
Note
General key symbols are used in this operating manual for all operating
steps. Details and differences when using the software terminal can be
found in the MIQ/IF232 component operating manual.