B&K Precision 2552-2559 - Manual - Manual (Page 24)

24
Auto Setup
The 2550 series Digital Storage Oscilloscopes have an Auto Setup function
that identifies the waveform types and automatically adjusts controls to
produce a usable display of the input signal.
Press the AUTO front panel button, and then press the menu option button
adjacent to the desired waveform as follows:
Figure 13 - Auto Setup
Note: For AUTO set to function properly, the signal frequency must
be > 5 Hz. There will be a short time delay when using AUTO to setup
4 channels.
Note: Do not connect a voltage source to the ground terminal or
it may damage the oscilloscope.