B&K Precision 2552-2559 - Manual - Manual (Page 82)

82
• Voltage Cursor: Voltage cursors appear as horizontal lines on
the display and measure the vertical parameters.
• Time Cursor: Time cursors appear as vertical lines on the
display and measure the horizontal parameters.
• Cursor Moving: Use the “Universal” knob to move cursor 1 and
cursor 2. They will be moved when the corresponding cursor
options are selected, and the cursor value will display on the
bottom left and top left of the screen when you move the cursor.
To do manual cursor measurements, follow these steps:
1. Press CURSOR button to enter the cursor function menu.
2. Press the “Cursor Mode” option button to select “Manual”.
3. Press the “Type” option button to select “Voltage” or “Time”
4. Press the “Source” option button to select “CH1”, “CH2”,
“CH3”, “CH4”, “MATH”, “FFT”, “REFA”, “REFB”,
“REFC”, “REFD”, according to input signal channel. (CH3,
CH4, REFC, and REFD available for 4CH models only)
5. Select “Cur A” and turn the “Universal” knob to adjust Cursor
A.
6. Select “Cur B” and turn the “Universal” knob to adjust Cursor
B.
7. The measurement values are displayed on the top left corner.
If the measurement type is set to “Voltage”, the values are as
follows:
The value of Cur A: Cur A
The value of Cur B: Cur B
The voltage difference between Cursor A and Cursor B: ∆V
If the measurement type is set to “Time”, the values are as
follows:
The value of Cur A: Cur A
The value of Cur B: Cur B
The time difference between Cursor A and Cursor B: ∆T
The reciprocal of time difference between Cursor A and
Cursor B: 1/∆T