Burkert Type 8630 - Manual (Page 13)

8630 - 11
G
ENERAL
N
OTES
Scope of delivery
Immediately after receipt of a shipment, make sure that the contents are undamaged and match the
scope of delivery stated on the packing slip. In general this consists of:
• Pneumatically actuated valve of type 2652, 2655, 2672, 2700, 2712, 2730, 2731 or 2731K with attached
TOP Control Continuous,
• Operating Instructions for the TOP Control Continuous and for the valve with pneumatic actuation.
If there are discrepancies, please contact immediately our customer service:
Bürkert Fluid Control Systems
Chr.-Bürkert-Str. 13-17
Service Department
D-76453 Ingelfingen
Tel.: (07940) 10-111
Fax: (07940) 10-448
E-Mail: [email protected]
NOTE Suitable cable plugs for the multipole connection are available as accessoires.
ATTENTION
EXERCISE CAUTION ON HANDLING!
ELECTROSTATICALLY SENSITITVE
COMPONENTS/MODULES
This device contains electronic components that are sensitive to
electrostatic discharge (ESD). Contact to electrostatically charged
persons or objects will endanger these components. In the worst
case, they will be immediately destroyed or will fail after
commissioning.
Observe the requirements of EN 100 015 - 1 in order to minimize
the possibility of, or avoid, damage from instantaneous electrostatic
discharge. Also take care not to touch components that are under
supply voltage.
Protection from damage by electrostatic charging
The warranty covers only faultless condition of the TOP Control Continuous and the
attached valve with pneumatic actuation. No liability will be accepted for consequential
damage of any kind that may arise from failure or malfunctioning of the device.
Warranty conditions
This document contains no warranty promises. We refer in this connection to our General Conditions of
Sale and Business. The condition for the warranty is use of the unit for the intended purpose under the
specified application conditions.
ATTENTION!