Burkert Type 8630 - Manual (Page 136)

134 - 8630
D
EVICE
N
ET
Explanation of terms
DeviceNet
• DeviceNet is a field bus system based on the CAN protocol (Controller Area Network). It permits the
networking of actuators and sensors (slaves) with higher ranking control devices (masters).
• In the DeviceNet the TOP Control Continuous is a slave device according to the Predefined Master/
Slave Connection Set defined in the DeviceNet specification. Polled I/0, Bit Strobed I/O and Change of
State (COS) are supported as I/O connection variants.
• With the DeviceNet a distinction is made between cyclic or event-controlled transferred process
messages of high priority (I/O Messages) and acyclic management messages of low priority (Explicit
Messages).
• The protocol sequence corresponds to DeviceNet Specification Release 2.0.
General notes
The following sections of the complete operating instructions are not applicable to the DeviceNet variant
of the TOP
Control Continuous 8630:
• Variants of the TOP Control Continuous
• First commissioning
• Electrical connection
• Defining the basic settings
Function INPUT
Function SPLTRNG
Function BIN-IN
Function OUTPUT
Function CAL.USER / CAL INP
Function CAL.USER / CAL OUT
Function CAL.USER / CAL SP