Burkert Type 8630 - Manual (Page 88)

86 - 8630
O
PERATION AND CONTROLLER FUNCTIONS
Operating the process
Each time after switching on the voltage supply, the TOP Control Continuous is automatically in the
process operating level. To get there from the configuration level, confirm the menu item END by
pressing the MANUAL/AUTOMATIC key.
In the process operating level, the normal controlled operation is executed and monitored (in the
AUTOMATIC mode), and the valve opened or closed by hand (MANUAL mode).
Changeover between operating modes
Operate the MANUAL/AUTOMATIC key to switch between the MANUAL and AUTOMATIC
modes.
Both in the MANUAL and the AUTOMATIC modes, you can change to the configuration
level by pressing the MANUAL/AUTOMATIC key for longer than 5 seconds. On switching
back to the process operating level, the operating mode is resumed that was set before
switching over.
5 sec
Operating mode yellow LED in the Display
MANUAL/AUTOMATIC key
AUTOMATIC flashes An apostrophe (') runs continuously
from left to right.
MANUAL off -