Burkert Type 8630 - Manual (Page 72)

70 - 8630
O
PERATION AND CONTROLLER FUNCTIONS
X.LIMIT
Limitation of the mechanical stroke range
Factory setting: LIM = 0%, LIM = 100%
This supplementary function limits the (physical) stroke to preset % values (minimum and maximum).
The range of the limited stroke is thereby set to 100 %.If the limited stroke range is left during operation,
negative or positive POS values greater than 100 % are displayed.
Entering the start value of the stroke range in %,
0 ... 50 % of the overall stroke
Entering the end value of the stroke rage in %,
50 ... 100 % of the overall stroke
The minimum separation between LIM and LIM
is 50 %.
XXX
XX
Setpoint [mA]
(INP)
limited
stroke
Limited
stroke [%]
(POS) Physical stroke
[%] (POS)
unlimited
stroke
Control r
ange in
automatic mode
Correcting r
ange in man
ual mode