Isolated power supply removal, Isolated power supply removal -18 – ZOLL E Series Monitor Defibrillator Rev D User Manual
Page 128
Advertising
E Series Service Manual
5-18
9650-1450-01 Rev. D
Isolated Power Supply Removal
1. Disconnect the molex connector.
2. Disconnect the 2 spade connectors.
3. Remove the 4 screws securing the board.
4a (Old Style MS-11) Carefully lift the isolated power supply
and remove long grey stranded cable (EtCO2), and the 2
flat cables, then remove board.
Note:
During reassembly route grey cable as shown in picture.
Advertising