High voltage assembly removal, High voltage assembly removal -23 – ZOLL E Series Monitor Defibrillator Rev D User Manual
Page 133
Advertising
1. Disconnect small flat cable by lifting up jams on each side and
pull straight out, then disconnect larger cable by pulling straight
out.
2. Disconnect J104 cable by lifting up jams on each side and
pull straight out.
3. Disconnect colored cable (MFC signal cable). Pull high voltage
module straight out.
4. Disconnect black cable. Remove screw holding plastic
cover in place. Slide plastic cover out.
E Series Service Manual
9650-1450-01 Rev. D
5-23
High Voltage Assembly Removal
Advertising