Battery interconnect board removal, Battery interconnect board removal -24 – ZOLL E Series Monitor Defibrillator Rev D User Manual
Page 134
Advertising
E Series Service Manual
5-24
9650-1450-01 Rev. D
Battery Interconnect Board Removal
1. Remove the 3 machine screws from the battery pins (J100,
J101, J102).
2. Remove the 2 screws securing the board.
3. Gently remove board by lifting from this end.
4. Disconnect flat cable by pulling gently.
Note:
Slightly lifting up on the charger assembly will allow for easier
removal.
Advertising