ZOLL X Series Monitor Defibrillator Rev H - Manual (Page 111)

Connecting the NIBP Cuff
9650-001355-01 Rev. H X Series Operator’s Guide 8-5
Connecting the NIBP Cuff
Connecting the NIBP cuff requires you to attach the inflation hose to the X Series unit and the
NIBP cuff. To use the SureBP feature, which enables the X Series unit to measure blood
pressure on cuff inflation, you must use the FlexiPort cuff and dual lumen (two-tube) adaptor
and hose. You can also use a single lumen (one-tube) hose and adaptor with the X Series unit,
but the unit will only measure blood pressure on cuff deflation.
To connect the NIBP cuff to the X Series unit:
1. Attach the inflation hose’s threaded metal connector to the NIBP connector on the side
panel of the X Series unit. Mesh the threads carefully so that the connector turns easily and
then turn the connector in a clockwise direction until it is snug. Attach a double lumen hose
as follows:
Figure 8-1 Attaching a Dual Lumen Hose to the X Series Unit