ZOLL X Series Monitor Defibrillator Rev H - Manual (Page 269)

Communications System Messages
9650-001355-01 Rev. H X Series Operator’s Guide 22–25
Communications System Messages
The X Series unit may display one of the following status messages during the transmission:
System Message Cause
TRYING TO CONNECT TO
NETWORK The unit is connecting to the network.
TRYING TO CONNECT TO
SERVER The unit is connecting to the ZOLL server.
TRANSMITTING The data transfer is in progress
TRANSMISSION COMPLETE The data transfer is complete.
TRANSMISSION FAILED The data transfer has failed.
To correct the problem, check the following:
•
Verify that wireless communications is enabled
on your X Series unit.
• Verify that the WiFi settings are correct in the
Communications setup menu.
• Verify that the ZOLL server is configured
correctly.
• Verify that your cellular device is configured
correctly.
• Make sure that the X Series unit is within range of
the wireless server.