ZOLL X Series Monitor Defibrillator Rev H - Manual (Page 284)

C HAPTER 24 M AINTENANCE
24-10 www.zoll.com 9650-001355-01 Rev. H
2. Refer to the illustration inside of the paper compartment for proper paper orientation, and
place a new roll of recorder paper on the empty spool.
3. Pull enough paper off the spool so that paper extends out of the unit when the printer cover
is closed.
4. Close the printer door. Be sure the cover is flush with the side of the unit.
Figure 24-2. Inserting the Paper and Closing Printer Door
5. After the paper is loaded, press the Print quick access key ( ) to resume printing.
Cleaning the Print Head
To clean the recorder print head, perform the following steps:
1. Pull the printer door open (see Fig. 24-1), then remove any paper.
2. Locate the print head along the front floor of the printer compartment.
3. Gently wipe the print head with a cotton swab moistened with isopropyl alcohol, and dry any
residual alcohol with another dry cotton swab.
Figure 24-3. Cleaning the Print Head
4. Place the paper back into the unit and close the cover (see Fig. 24-2).