ZOLL X Series Monitor Defibrillator Rev H - Manual (Page 92)

C HAPTER 6 M ONITORING ECG
6-6 www.zoll.com 9650-001355-01 Rev. H
Selecting ECG Waveforms for Display
You can fit up to four waveforms on the X Series display. The first waveform at the top of the
display is always an ECG waveform. (If
Pads are not connected, the unit can be configured to
automatically default to another ECG lead.) In the following example, Lead II (RA-LL), is the
source of the ECG waveform trace:
The X Series unit is configured to display Pads by default for the top trace. If configured, the
unit can also display four ECG traces on startup, when no other monitoring devices are
attached.
The are two ways to specify which ECG lead is the source of the primary waveform trace. One
way is to press the ECG lead selection quick access key to display the available ECG
waveform sources. The available waveform sources are determined by the type of ECG cable
connected to the unit.
The other way to specify the source of the primary waveform trace is to navigate to and select
the source label for the primary ECG waveform (Lead
l in the screen below). The X Series unit
then displays the available ECG waveform sources. The following example illustrates the
waveform source list that the X Series unit displays when a 5-lead ECG cable is connected to it.
The list of available ECG waveform sources includes Leads
I , II , III , aVR , aVL , aVF , and V . You
can select Lead lI (the default), or use the navigation keys to highlight and select another
displayed ECG lead as the source for the waveform trace.
06/06/2011
I, II,
III...
SYNC
12
CO
2
R
I, II,
III...